Chapter 28 ARP Inspection
GS2220 Series User’s Guide
277
28.2.1 ARP Inspe c tio n Po rt C o nfig ure
Use this screen to specify whether ports are trusted or untrusted ports for ARP inspection. You can also
specify the maximum rate at which the Switch receives ARP packets on each untrusted port. To open
this screen, click Adva nc ed Applic a tio n > IP So urc e G ua rd > IPv4 So urc e G ua rd Se tup > ARP Inspe c tio n >
Config ure > Port.
Fig ure 208 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure > Port
The following table describes the labels in this screen.
Apply Click Ap ply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click this to reset the values in this screen to their last-saved values.
Table 129 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure (continued)
LABEL DESCRIPTIO N
Table 130 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure > Port
LABEL DESC RIPTIO N
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make
them.
To Next Page
Loading...
