GS2220 Series User’s Guide
435
51.3 Cluste ring Ma na g e m e nt Co nfig ura tio n
Use this screen to configure clustering management. Click Ma na g e m e nt > C luste r Ma na g e me nt >
Config ura tio n to display the next screen.
Fig ure 333 Management > Cluster Management > Configuration
The following table describes the labels in this screen.
Model This field displays the model name.
Status This field displays:
O nline (the cluster member Switch is accessible)
Error (for example the cluster member Switch password was changed or the Switch was set as
the manager and so left the member list, and so on)
O ffline (the Switch is disconnected – O ffline shows approximately 1.5 minutes after the link
between cluster member and manager goes down)
Table 228 Management > Cluster Management Status (continued)
LABEL DESC RIPTIO N
Table 229 Management > Cluster Management > Configuration
LABEL DESC RIPTIO N
Clustering Manager The following fields relate to configuring the cluster manager.
Active Select Ac tive to have this Switch become the cluster manager switch. A cluster can only
have one manager. Other (directly connected) switches that are set to be cluster
managers will not be visible in the Cluste ring C a ndida te s list. If a switch that was previously a
cluster member is later set to become a cluster manager, then its Sta tus is displayed as Erro r
in the Cluste r Ma na g e m e nt Sta tus screen and a warning icon ( ) appears in the member
summary list below.
Name Type a name to identify the Cluste ring Ma na g e r. You may use up to 32 printable characters
(spaces are allowed).
To Next Page
Loading...
