Chapter 5 Initial Setup Example
GS2220 Series User’s Guide
81
Switch’s power is turned off.
5.1.2 Se t Po rt VID
Use PVID to add a tag to incoming untagged frames received on that port so that the frames are
forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any untagged frames received on
that port get sent to VLAN 2.
Fig ure 58 Initial Setup Network Example: Port VID
1 Click Adva nc e d Applic a tio n > VLAN > VLAN C o nfig ura tio n in the navigation panel. Then click the VLAN
Po rt Se tup link.
2 Enter 2 in the PVID field for port 1 and click Apply to save your changes back to the run-time memory.
Settings in the run-time memory are lost when the Switch’s power is turned off.
To Next Page
Loading...
