Chapter 5 Initial Setup Example
GS2220 Series User’s Guide
80
2 In the Sta tic VLAN screen, select AC TIVE, enter a descriptive name in the Na m e field and enter 2 in the
VLAN G ro up ID field for the VLAN2 network.
Note: The VLAN Gro up ID field in this screen and the VID field in the IP Se tup screen refer to the
same VLAN ID.
3 Since the VLAN2 network is connected to port 1 on the Switch, select Fixe d to configure port 1 to be a
permanent member of the VLAN only.
4 To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames properly, clear
the TX Ta g g ing check box to set the Switch to remove VLAN tags before sending.
5 Click Add to save the settings to the run-time memory. Settings in the run-time memory are lost when the
To Next Page
Loading...
