Chapter 28 ARP Inspection
GS2220 Series User’s Guide
283
28.7 IPv6 So urc e G ua rd Po rt Se tup
Use this screen to apply configured IPv6 source guard policies to ports you specify. Use port * to apply a
policy to all ports. To open this screen, click Adva nc e d Applic a tio n > IP Sourc e G ua rd > IPv6 So urc e
G ua rd Po rt Se tup.
Fig ure 213 Advanced Application > IP Source Guard > IPv6 Source Guard Port Setup
The following table describes the labels in this screen.
Clear Click this to clear the fields above.
Index This field displays a sequential number for each policy.
Name This field displays the descriptive name for identification purposes for this IPv6 source guard
policy.
Validate Address This field displays the Va lida te Addre ss status for this IPv6 source guard policy.
Validate Prefix This field displays the Va lida te Pre fix status for this IPv6 source guard policy.
Link Local This field displays the Link Lo c a l traffic status for this IPv6 source guard policy.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Select an entry check box and click De le te to remove the specified entry.
Cancel Click this to clear the De le te check boxes above.
Table 134 Advanced Application > IP Source Guard > IPv6 Source Guard Policy Setup (continued)
LABEL DESCRIPTIO N
Table 135 Advanced Application > IP Source Guard > IPv6 Source Guard Port Setup
LABEL DESCRIPTIO N
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Policy Name Select an IPv6 source guard policy that the Switch will apply to this port.
To Next Page
Loading...
