Chapter 8 Basic Setting
GS2220 Series User’s Guide
111
8.6.4 Ne two rk Pro xy C o nfig ura tion
The proxy server of an organization may prohibit communication between the Switch and NCC (Nebula
Control Center) (
Section 8.11 on page 131). Use this screen to enable communication between the
Switch and NCC through the proxy server.
IP Subnet
Mask
Enter the IP subnet mask of an IP routing domain in dotted decimal notation, for example,
255.255.252.0.
Default
Gateway
Type the IP address of the default outgoing gateway in dotted decimal notation, for example
172.21.43.254.
VID Enter the VLAN identification number to which an IP routing domain belongs.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click C a nc e l to reset the fields to your previous configuration.
Management IP Address
Use these fields to configure the settings for the management port.
IP Address Enter the out-of-band management IP address of your Switch in dotted decimal notation. For
example, 192.168.0.1.
IP Subnet
Mask
Enter the IP subnet mask of your Switch in dotted decimal notation, for example, 255.255.255.0.
VID Enter the VLAN identification number to which an IP routing domain belongs.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation, for example,
192.168.0.254.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Sa ve link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel Click C a nc e l to reset the fields to your previous configuration.
Index This field displays the index number of an entry.
IP Address This field displays the IP address of the Switch in the IP domain.
IP Subnet Mask This field displays the subnet mask of the Switch in the IP domain.
VID This field displays the VLAN identification number of the IP domain on the Switch.
Default
Gateway
This field displays the IP address of the default outgoing gateway in dotted decimal notation.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click De le te to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out of the Switch.
Cancel Click Ca nc e l to clear the check boxes.
Table 31 Basic Setting > IP Setup > IP Configuration (continued)
LABEL DESC RIPTIO N
To Next Page
Loading...
