ZyXEL Communications GS2220 Series - Poe Setup

Chapter 8 Basic Setting
GS2220 Series User’s Guide
117
Fig ure 93 Basic Setting > PoE Setup > PoE Time Range Setup
The following table describes the labels in this screen.
8.8.2 Po E Se tup
Use this screen to set the PoE power management mode, priority levels, power-up mode and the
maximum amount of power for the connected PDs.
Click the PoE Se tup link in the Ba sic Se tting > Po E Sta tus screen. The following screen opens.
Table 35 Basic Setting > PoE Setup > PoE Time Range Setup
LABEL DESCRIPTIO N
Port Enter the number of the port to which you want to apply a schedule.
Time Range This field displays the name of the schedule that you have created using the Adva nc e d
App lic a tio n > Time Ra ng e screen.
Select a pre-defined schedule to control when the Switch enables PoE to provide power on the
port. To select more than one schedule, press [SHIFT] and select the choices at the same time.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Cle a r to clear the fields to the factory defaults.
Port This field displays the index number of the port. Click a port number to change the schedule
settings.
Time Range
Profiles
This field displays the name of the schedule which is applied to the port.
PoE is enabled at the specified time or date.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Check the rules that you want to remove and then click the De le te button.
Cancel Click C a nc e l to clear the selected check boxes.