ZyXEL Communications GS2220 Series - Ipv6 Neighbor Setup

Chapter 8 Basic Setting
GS2220 Series User’s Guide
129
8.10.9 IPv6 Ne ig hb o r Se tup
Use this screen to create a static IPv6 neighbor entry in the Switch’s IPv6 neighbor table to store the
neighbor information permanently. Click the link next to IPv6 Ne ig hbo r Se tup in the IPv6 Co nfig ura tio n
screen to display the screen as shown next.
Fig ure 104 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
The following table describes the labels in this screen.
NS Interval This field displays the time interval (in milliseconds) at which neighbor solicitations are re-sent for
this interface.
Reachable
Time
This field displays how long (in milliseconds) a neighbor is considered reachable for this interface.
Table 45 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Discovery Setup (continued)
LABEL DESC RIPTIO N
Table 46 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
LABEL DESC RIPTIO N
Interface Type Select the type of IPv6 interface for which you want to configure. The Switch supports the VLAN
interface type for IPv6 at the time of writing.
Interface ID Specify a unique identification number (from 1 to 4094) for the interface.
A static IPv6 neighbor entry displays in the Ma na g e m e nt > IPv6 Ne ig hbo r Ta b le screen only when
the interface ID is also created in the Ba sic Se tup > Inte rfa c e Se tup screen.
To have IPv6 function properly, you should configure a static VLAN with the same ID number in the
Adva nc e d App lic a tio n > VLAN screens.
Neighbor
Address
Specify the IPv6 address of the neighboring device which can be reached through the interface.
MAC Specify the MAC address of the neighboring device which can be reached through the
interface.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Sa ve link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel Click C a nc e l to begin configuring this screen afresh.
Clear Click Cle a r to reset the fields to the factory defaults.
Index This is the interface index number. Click an index number to change the settings.