ZyXEL Communications GS2220 Series - Zyxel One Network (ZON) Utility; Requirements

Chapter 4 Web Configurator
GS2220 Series User’s Guide
54
4.3 Zyxe l O ne Ne two rk (ZO N) Utility
ZON Utility is a program designed to help you deploy and manage a network more efficiently. It detects
devices automatically and allows you to do basic settings on devices in the network without having to
be near it.
The ZON Utility issues requests through Zyxel Discovery Protocol (ZDP) and in response to the query, the
device responds back with basic information including IP address, firmware version, location, system
and model name in the same broadcast domain. The information is then displayed in the ZON Utility
screen and you can perform tasks like basic configuration of the devices and batch firmware upgrade
in it. You can download the ZON Utility at www.zyxel.com and install it in a computer (Windows
operating system).
4.3.1 Re quire me nts
Before installing the ZON Utility in your computer, please make sure it meets the requirements listed
below.
O pe ra ting Syste m
At the time of writing, the ZON Utility is compatible with:
• Windows 7 (both 32-bit / 64-bit versions)
• Windows 8 (both 32-bit / 64-bit versions)
• Windows 8.1 (both 32-bit / 64-bit versions)
• Windows 10 (both 32-bit / 64-bit versions)
Note: To check for your Windows operating system version, right-click on My Co m pute r >
Pro pe rtie s. You should see this information in the G e ne ra l tab.
Ha rdwa re
Here are the minimum hardware requirements to use the ZON Utility on your computer.
• Core i3 processor
Set Community Enter the Se t Co m m unity string, which is the password for the incoming Set- requests from the
management station.
The Se t Co mm unity string is only used by SNMP managers using SNMP version 2c or lower.
Trap Community Enter the Tra p Co m m unity string, which is the password sent with each trap to the SNMP
manager.
The Tra p Co m m unity string is only used by SNMP managers using SNMP version 2c or lower.
Apply Click Ap ply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Table 5 Web Configurator: Password/SNMP (continued)
LABEL DESC RIPTIO N