ZyXEL Communications GS2220 Series - Page 53

Chapter 4 Web Configurator
GS2220 Series User’s Guide
53
Pa sswo rd/ SNMP Se tting
Fig ure 37 Web Configurator: Warning
Fig ure 38 Web Configurator: Password
Change the default administrator and/or SNMP passwords, and then click Apply to save your changes.
Table 5 Web Configurator: Password/SNMP
LABEL DESC RIPTIO N
Administrator
This is the default administrator account with the “admin” user name. You cannot change the default administrator
user name.
Old Password Type the existing system password (1234 is the default password when shipped).
New Password Enter your new system password. Up to 32 characters are allowed for the new password
except [ ? ], [ | ], [ ' ], [ " ], [ space ], or [ , ].
Retype to confirm Retype your new system password for confirmation.
General Setting
Use this section to specify the SNMP version and community (password) values.
Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the version
on the SNMP manager. Choose SNMP version 2c (v2c ), SNMP version 3 (v3) or both (v3v2c ).
Note: SNMP version 2c is backwards compatible with SNMP version 1.
Get Community Enter the G e t C o mm unity string, which is the password for the incoming Get- and GetNext-
requests from the management station.
The G e t Co m munity string is only used by SNMP managers using SNMP version 2c or lower.