ZyXEL Communications GS2220 Series - Link Aggregation Control Protocol

Chapter 17 Link Aggregation
GS2220 Series User’s Guide
191
17.3.1 Link Ag g re g a tio n C o ntro l Pro to c o l
Click Adva nc e d Applic a tio n > Link Ag g re g a tio n > Link Ag g re g a tio n Se tting > LAC P to display the screen
shown next. See Dynamic Link Aggregation on page 187 for more information on dynamic link
aggregation.
Fig ure 150 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Table 79 Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL DESC RIPTIO N
Table 80 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL DESCRIPTIO N
Link
Aggregation
Control
Protocol
Note: Do NOT configure this screen unless you want to enable dynamic link
aggregation.
Active Select this check box to enable Link Aggregation Control Protocol (LACP).
System Priority LACP system priority is a number between 1 and 65535. The switch with the lowest system priority
(and lowest port number if system priority is the same) becomes the LACP “server”. The LACP
“server” controls the operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority
level.