Chapter 9 VLAN
GS2220 Series User’s Guide
140
Fig ure 114 Advanced Application > VLAN > VLAN Configuration > Static VLAN Setup
The following table describes the related labels in this screen.
Table 52 Advanced Application > VLAN > VLAN Configuration > Static VLAN Setup
LABEL DESCRIPTIO N
ACTIVE Select this check box to activate the VLAN settings.
Name Enter a descriptive name for the VLAN group for identification purposes. This name consists of up
to 64 printable characters. Spaces are allowed.
VLAN Group ID Enter the VLAN ID for this static entry; the valid range is between 1 and 4094.
Note: Do NOT add a VLAN ID that has been used in the Vo ic e VLAN Se tup.
Port The port number identifies the port you are configuring.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Control Select Norm a l for the port to dynamically join this VLAN group. This is the default selection.
Select Fixe d for the port to be a permanent member of this VLAN group.
Select Fo rbidde n if you want to prohibit the port from joining this VLAN group.
Tagging Select TX Ta g g ing if you want outgoing traffic to contain this VLAN tag.
Otherwise, to ensure that VLAN-unaware devices (such as computers and hubs) can receive
frames properly, clear the TX Ta g g ing check box to set the Switch to remove VLAN tags before
sending.
To Next Page
Loading...
