Chapter 60 Port
GS2220 Series User’s Guide
466
Fig ure 353 Port > PoE Setup > PoE Status
The following table describes the labels in this screen.
Table 244 Port > PoE Setup > PoE Status
LABEL DESCRIPTIO N
PoE Mode This field displays the power management mode used by the Switch, whether it is in
Cla ssific a tio n or Co nsum ptio n mode.
Total Power (W) This field displays the total power the Switch can provide to the connected PoE-enabled
devices on the PoE ports.
PoE Usage (%) This field displays the amount of power currently being supplied to connected PoE devices (PDs)
as a percentage of the total PoE power the Switch can supply.
When PoE usage reaches 100%, the Switch will shut down PDs one-by-one according to the PD
priority which you configured in Po rt > Po E Se tup > Po E Se tup.
Consuming
Power (W)
This field displays the amount of power the Switch is currently supplying to the connected PoE-
enabled devices.
Allocated Power
(W)
This field displays the total amount of power the Switch (in classification mode) has reserved for
PoE after negotiating with the connected PoE devices. It shows NA when the Switch is in
consumption mode.
Co nsum ing Po we r (W) can be less than or equal but not more than the Alloc a te d Po we r (W).
Remaining
Power (W)
This field displays the amount of power the Switch can still provide for PoE.
Note: The Switch must have at least 16 W of remaining power in order to supply
power to a PoE device, even if the PoE device needs less than 16 W.
Port This is the port index number.
State This field shows which ports can receive power from the Switch. You can set this in
Section 60.3
on page 467
.
• Disa ble – The PD connected to this port cannot get power supply.
• Ena b le – The PD connected to this port can receive power.
To Next Page
Loading...
