ZyXEL Communications GS2220 Series - Page 241

Chapter 24 Multicast
GS2220 Series User’s Guide
241
Fig ure 184 Advanced Application > Multicast > MVR
The following table describes the related labels in this screen.
Table 107 Advanced Application > Multicast > MVR
LABEL DESC RIPTIO N
Active Select this check box to enable MVR to allow one single multicast VLAN to be shared among
different subscriber VLANs on the network.
Group Name Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes.
Multicast VLAN ID Enter the VLAN ID (1 to 4094) of the multicast VLAN.
802.1p Priority Select a priority level (0 – 7) with which the Switch replaces the priority in outgoing IGMP or
MLD control packets (belonging to this multicast VLAN).
Mode Specify the MVR mode on the Switch. Choices are Dyna m ic and C o m pa tib le .
Select Dynam ic to send IGMP reports or MLD messages to all MVR source ports in the multicast
VLAN.
Select C om pa tib le to set the Switch not to send IGMP reports or MLD messages.
Port This field displays the port number on the Switch.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.