Chapter 43 Differentiated Services
GS2220 Series User’s Guide
369
Fig ure 280 IP Application > DiffServ > DSCP Setting
The following table describes the labels in this screen.
Table 188 IP Application > DiffServ > DSCP Setting
LABEL DESCRIPTIO N
0 … 63 This is the DSCP classification identification number.
To set the IEEE 802.1p priority mapping, select the priority level from the drop-down list box.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Sa ve link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
To Next Page
Loading...
