Chapter 45 ARP Setup
GS2220 Series User’s Guide
386
Fig ure 295 IP Application > ARP Setup > ARP Learning
The following table describes the labels in this screen.
Table 201 IP Application > ARP Setup > ARP Learning
LABEL DESCRIPTIO N
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
ARP Learning
Mode
Select the ARP learning mode the Switch uses on the port.
Select ARP- Re p ly to have the Switch update the ARP table only with the ARP replies to the ARP
requests sent by the Switch.
Select G ra tuito us- A RP to have the Switch update its ARP table with either an ARP reply or a
gratuitous ARP request.
Select ARP- Re que st to have the Switch update the ARP table with both ARP replies, gratuitous
ARP requests and ARP requests.
Apply Click App ly to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click C a nc e l to begin configuring this screen afresh.
To Next Page
Loading...
