ZyXEL Communications GS2220 Series - Page 413

Chapter 47 Access Control
GS2220 Series User’s Guide
413
fanspeed zyHwMonitorFanSpeedOutO
fRange
1.3.6.1.4.1.890.1.15.3.26.2.1 This trap is sent when the fan speed goes
above or below the normal operating
range.
zyHwMonitorFANSpeedOut
OfRangeRecovered
1.3.6.1.4.1.890.1.15.3.26.2.6 This trap is sent when the fan speed is
recovered from the out of range to normal
operating range.
temperature zyHwMonitorTemperatureOu
tOfRange
1.3.6.1.4.1.890.1.15.3.26.2.2 This trap is sent when the temperature goes
above or below the normal operating
range.
zyHwMonitorTemperatureOu
tOfRangeRecovered
1.3.6.1.4.1.890.1.15.3.26.2.7 This trap is sent when the temperature is
recovered from the out of range to normal
operating range.
voltage zyHwMonitorPowerSupplyVo
ltageOutOfRange
1.3.6.1.4.1.890.1.15.3.26.2.3 This trap is sent when the voltage goes
above or below the normal operating
range.
reset zySysMgmtUncontrolledSyste
mReset
1.3.6.1.4.1.890.1.15.3.49.2.1 This trap is sent when the Switch
automatically resets.
zySysMgmtControlledSystem
Reset
1.3.6.1.4.1.890.1.15.3.49.2.2 This trap is sent when the Switch resets by
an administrator through a management
interface.
zySysMgmtBootImageIncons
istence
1.3.6.1.4.1.890.1.15.3.49.2.3 This trap is sent when the index number of
image which is loaded when the Switch
starts up is different from what is specified
through the CLI.
RebootEvent 1.3.6.1.4.1.890.1.5.1.1.2 This trap is sent when the Switch reboots by
an administrator through a management
interface.
timesync zyDateTimeTrapTimeServerN
otReachable
1.3.6.1.4.1.890.1.15.3.82.3.1 This trap is sent when the Switch’s date and
time is not manually entered or the
specified time server is not reachable.
zyDateTimeTrapTimeServerN
otReachableRecovered
1.3.6.1.4.1.890.1.15.3.82.3.2 This trap is sent when the Switch’s real time
clock is up to date.
loopguard zyLoopGuardLoopDetect 1.3.6.1.4.1.890.1.15.3.45.2.1 This trap is sent when loopguard shuts down
a port.
errdisable zyErrdisableDetect 1.3.6.1.4.1.890.1.15.3.24.4.1 This trap is sent when an error is detected
on a port, such as a loop occurs or the rate
limit for specific control packets is
exceeded.
zyErrdisableRecovery 1.3.6.1.4.1.890.1.15.3.24.4.2 This trap is sent when the Switch ceases the
action taken on a port, such as shutting
down the port or discarding packets on the
port, after the specified recovery interval.
Table 219 SNMP System Traps (continued)
O PTIO N O BJEC T LABEL O BJECT ID DESC RIPTIO N