Chapter 3 Hardware Panels
GS2220 Series User’s Guide
42
yo u insta ll or re m o ve a tra nsc e ive r.
STO RAG E! All m o dule s a re dust se nsitive . Whe n no t in use , a lwa ys ke e p
the dust plug o n. Avo id g e tting dust a nd o the r c o nta m ina nt into the
o ptic a l bore s, a s the o ptic s do no t work c o rre c tly whe n o bstruc te d with
dust.
3.1.3.1 Tra nsc e ive r Insta lla tio n
Use the following steps to install a transceiver.
1 Attach an ESD preventive wrist strap to your wrist and to a bare metal surface.
2 Align the transceiver in front of the slot opening.
3 Make sure the latch is in the lock position (latch styles vary), then insert the transceiver into the slot with
the exposed section of PCB board facing down.
4 Press the transceiver firmly until it clicks into place.
5 The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is functioning
properly.
6 Remove the dust plugs from the transceiver and cables (dust plug styles vary).
7 Identify the signal transmission direction of the fiber cables and the transceiver. Insert the fiber cable into
the transceiver.
Fig ure 18 Latch in the Lock Position
Fig ure 19 Transceiver Installation Example
Fig ure 20 Connecting the Fiber Cables
3.1.3.2 Tra nsc e ive r Re m ova l
Use the following steps to remove an SFP transceiver.
To Next Page
Loading...
