EasyManuals Logo

ZyXEL Communications GS2220 Series User Manual

ZyXEL Communications GS2220 Series
556 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #478 background imageLoading...
Page #478 background image
Chapter 61 Switching
GS2220 Series User’s Guide
478
Fig ure 360 Switching > Link Aggregation > Link Aggregation Control Protocol
The following table describes the labels in this screen.
Table 250 Switching > Link Aggregation > Link Aggregation Control Protocol
LABEL DESCRIPTIO N
Link
Aggregation
Control
Protocol
Note: Do NOT configure this screen unless you want to enable dynamic link
aggregation.
Active Set this switch to O N to enable Link Aggregation Control Protocol (LACP).
System Priority LACP system priority is a number between 1 and 65535. The switch with the lowest system priority
(and lowest port number if system priority is the same) becomes the LACP “server”. The LACP
“server” controls the operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority
level.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports.
LACP Active Select this option to enable LACP for a trunk.
Port This field displays the port number.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ZyXEL Communications GS2220 Series and is the answer not in the manual?

ZyXEL Communications GS2220 Series Specifications

General IconGeneral
BrandZyXEL Communications
ModelGS2220 Series
CategorySwitch
LanguageEnglish

Related product manuals