Chapter 63 Security
GS2220 Series User’s Guide
507
Fig ure 382 Security > Access Control > SNMP > Trap Group Port
The following table describes the labels in this screen.
Table 271 Security > Access Control > SNMP > Trap Group Port
LABEL DESC RIPTIO N
Option Select the trap type you want to configure here.
Port This field displays a port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Active Set this switch to O N to enable the trap type of SNMP traps on this port.
Set this switch to O FF to disable the sending of SNMP traps on this port.
Apply Click Ap ply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
To Next Page
Loading...
