Chapter 4 Web Configurator
GS2220 Series User’s Guide
68
After clicking Ne xt, the Summ a ry screen appears.
Fig ure 53 Wizard > Advanced Settings > Step 4 Summary
Each field is described in the following table.
Select all ports After you create a VLAN, select the ports to be assigned to the Networked AV VLAN.
Se le c t a ll ports to assign the same role all ports.
You can select a port by clicking it. Then click any of the following:
Click Tx/ Rx to assign the ports for connecting to networked audio and video equipments.
Click Inte r- switc h to assign the ports for connecting to other switches.
Click Ma na g e me nt to assign the ports for connecting to non-Audio-Video equipment (for
example, computer and NAS).
See
Table 11 on page 62 for the default settings based on the port role.
Link aggregate Select this option to aggregate multiple port bandwidth if you are connecting to another
switch. Link aggregation (trunking) is the grouping of physical ports into one logical higher-
capacity link.
Previous Click Pre vio us to show the previous screen.
Next Click Ne xt to show the next screen.
Cancel Click Ca nc e l to exit this screen without saving.
Table 16 Wizard > Advanced Settings > Step 4 Summary
LABEL DESC RIPTIO N
Setup IP
Host Name This field displays a host name.
Table 15 Wizard > Advanced Settings > Step 3 Networked AV
LABEL DESC RIPTIO N
To Next Page
Loading...
