6166 DC Voltage Current Source Operation Manual
4.2.13 MENU Key (Parameter Setting)
4-6
PARAM Loads or saves the setting parameters.
Power ON Load Selects the setting parameter condition at power ON.
Power OFF: Start up using the parameters saved when the power was last turned
off.
USER0: Start up using the parameters saved in the non-volatile memory,
USER0.
Param Save Saves the setting parameters to the non-volatile memory.
USER0: Saves the current setting parameters to the non-volatile memory, USER0.
USER1: Saves the current setting parameters to the non-volatile memory, USER1.
USER2: Saves the current setting parameters to the non-volatile memory, USER2.
USER3: Saves the current setting parameters to the non-volatile memory, USER3.
USER0-3 Default: Saves the factory default values to the non-volatile memory,
USER0 to USER3
Param Load Loads the setting parameters saved in the non-volatile memory.
Not displayed on the menu screen while Operate is ON.
USER0: Loads the parameters from the non-volatile memory, USER0.
USER1: Loads the parameters from the non-volatile memory, USER1.
USER2: Loads the parameters from the non-volatile memory, USER2.
USER3: Loads the parameters from the non-volatile memory, USER3.
Default: Loads the factory default values as setting parameters.
Initialize Initializes all the setting parameters to the factory default values.
I/F Selects or sets the interface.
Bus Selects the interface.
GPIB: Selects the GPIB interface.
USB: Selects the USB interface.
BCD: Selects the BCD interface.
BCD is displayed only in the 6161-compatible operation.
Address Sets the GPIB address from 0 to 30.
NOT displayed when the USB interface is selected.
Header Sets the header of the talker format to ON or OFF.
Displayed only in the 6161-compatible operation.
OFF: Not output the header.
ON: Outputs the header.
Listen Only Switches between Addressable and Listen only.
NOT displayed when the USB interface is selected.
OFF: Addressable
ON: Listen only
Id Sets the USB ID from 1 to 127.
NOT displayed when the GPIB interface is selected.
To Next Page
Loading...
