ADCMT 6166 User Manual

6166 DC Voltage Current Source Operation Manual
6.6.4 Remote Command List
6-42
System Parameter load *RCL0 Loads data from the non-volatile mem-
ory, USER0 as setting parameters.
--
*RCL1 Loads data from the non-volatile mem-
ory, USER1 as setting parameters.
*RCL2 Loads data from the non-volatile mem-
ory, USER2 as setting parameters.
*RCL3 Loads data from the non-volatile mem-
ory, USER3 as setting parameters.
RINI Loads the factory default settings as set-
ting parameters.
--
Maximum
relay count
ORLY? Reads the maximum relay count.
Response:
dddddddddd (10-digit integers)
Cali-
bration
Calibration
mode
CAL0 OFF (Exits the calibration mode.)
CAL1 ON (Enters the calibration mode.)
CAL? Query of calibration mode
Response: CAL0 or CAL1
Calibration
data
XINI Initializes the calibration data area.
- Not initialize calibration data in the
non-volatile memory.
----
XCLR Initializes the present calibration data
such as function, range and polarity.
- Not initialize calibration data in the
non-volatile memory.
----
XWR Saves calibration data to the non-vola-
tile memory.
----
XOUT Cancels the calibration mode (OFF).
----
The calibration coefficient is not saved.
Calibration
function
XF5 Connection coefficient calibration
----
XF6 Connection coefficient calibration
XF0 Voltage source calibration
XF1 Divider voltage source calibration
XF2 Current source calibration
XF3 Voltage limit calibration
XF4 Current limit calibration
XF? Query of calibration function
----
Response: XF0 to XF6
Class Item Command Description
Default Operation
Power
ON
Factory
shipment
Divider
function
Thermal
electrom
otive
force
function
Scan
stopped
Scan
running
CAL

ADCMT 6166 Specifications

General

Brand	ADCMT
Model	6166
Category	Measuring Instruments
Language	English