!"
97;
*Branch to undefined label* Step nnn (–412)
Explanation: A program instruction references a program label that is not defined
in the program. Either the label is missing or was mistyped when
defined or in the reference.
User action: Check the label definition and reference.
Breakpoint at (task) program_name, step n (17)
Explanation: A breakpoint was encountered before the indicated step. (Any out-
put associated with the breakpoint is displayed after the message
shown above.)
User action: Enter a PROCEED (CTRL+P), RETRY, SSTEP (CTRL+Z), or XSTEP
(CTRL+X) command to resume program execution.
1
Otherwise,
enter any other monitor command.
*Breakpoint not allowed here* (–380)
Explanation: An attempt has been made to set a breakpoint before the first exe-
cutable statement of a program.
User action: Enter a new BPT command specifying a step after the first execut-
able statement. That is, after the .PROGRAM statement, any AUTO
and LOCAL statements, and all comments and blank lines at the
start of the program.
*Calibration program not loaded* (–425)
Explanation: A program required for calibration has not been loaded from disk.
This error usually occurs if some of the calibration programs have
not been loaded into memory, and the CALIBRATE command or
instruction is issued with a input mode that does not allow them to
be loaded automatically.
User Action: Reissue the CALIBRATE command or instruction with the proper
mode. The default mode of zero causes CALIBRATE to automati-
cally load the required programs from disk, perform the calibration,
and then delete the programs.
1
The command keys CTRL+P, CTRL+X, and CTRL+Z are accepted only while using the V
+
program debugger in its monitor mode.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
