!"
9&/
During MANUAL mode, releasing this switch performs a con-
trolled power-off rather than an E-STOP.
User action: Hold the user enable switch and reenable HIGH POWER as desired.
If the switch was already pressed, check the switch and the associ-
ated connectors and wiring.
Executing in DRY.RUN mode (50)
Explanation: The DRY.RUN switch is enabled and program execution has been
requested. Thus, no motion of the robot will occur.
User action: None unless motion of the robot is desired. In that case, abort execu-
tion of the program and disable the DRY.RUN switch.
*Expected character(s) not found* (–745)
Explanation: While training characters for subsequent optical character recogni-
tion (OCR), the number of characters in the given string did not cor-
respond to the number of characters found in the training window.
Character training has been aborted.
User action: Make sure the given string matches the characters in the training
window.
*[Fatal] Addr Err* at aaaaaa m:n I=xxxx, A=aaaa, F=ff (None)
Explanation: An internal problem has occurred with the V
+
software or with the
system hardware.
User action: It would be appreciated if you would report the error to Adept
Application Engineering. Please include the details of the error mes-
sage and exactly what you were doing at the time the error
occurred.
To save programs that are in memory, you can restart V
+
tempo-
rarily by pressing CTRL+G. The robot servos will not function, but
you can STORE the programs. Then power down the controller and
restart the system.
*[Fatal] Bus Err* at aaaaaa m:n I=xxxx, t=aaaa, F=ff (None)
Explanation: A computer error occurred because of a bad read from memory,
because of noise on the internal data bus, or because of a hardware
problem.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
