!"
9<9
Engineering. Please include the details of the error message and
what you were doing at the time the error occurred.
To save programs that are in memory, you can restart V
+
tempo-
rarily by pressing CTRL+G. The robot servos will not function, but
you can STORE the programs. Then power down the controller and
restart the system.
*[Fatal] System clock dead* (None)
Explanation: During initial startup, V
+
has failed to detect proper operation of the
system clock and timer hardware. V
+
cannot run without the clock
operating properly.
User action: Power down the controller and try starting it again. If the problem
persists, contact Adept Customer Service.
*[Fatal] System clock too fast* (None)
Explanation: During initial startup, V
+
has detected that the system hardware
clock is running too fast. V
+
cannot run without the clock operating
properly.
User action: Power down the controller and try starting it again. If the problem
persists, contact Adept Customer Service.
*File already exists* (–500)
Explanation: There is already a disk file or a graphics window with the name
supplied to the last storage request.
User action: Reissue the storage request with a different file name, or delete the
old file.
*File already open* (–506)
Explanation: A disk file or graphics window is already open on a logical unit, and
another open request has been attempted.
User action: Modify the program to use a different logical unit number for the
file or window you want to open, or perform an FCLOSE operation
on the file or window currently open on the specified logical unit
number before performing the FOPEN operation.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
