!"
9<2
*First statement must be .PROGRAM* (–351)
Explanation: An attempt was made to insert or deposit a program statement
above the .PROGRAM statement, which must be the first statement
in the program.
User action: Move the cursor to below the .PROGRAM line of the program
before attempting to insert or deposit statements.
*Font already defined* (–737)
Explanation: An attempt has been made to VLOAD a font file (for subsequent
optical character recognition) that contains a font with the same
number as one already in memory. The load operation has been
aborted and none of the fonts in the file have been loaded.
User action: Rename or delete the font currently defined in memory.
*Font not completely trained* (–738)
Explanation: During planning of a font for optical character recognition (OCR),
some or all of the characters in the font have not been trained.
User action: Display the font (with VSHOW.FONT) to see which characters have
not been trained. Then train those characters or delete them from
the font.
*Font not defined* (–736)
Explanation: The font specified for optical character recognition (OCR) is not
defined.
User action: Use VDEF.FONT or VLOAD to define the font.
*Font not loaded* (–551)
Explanation: The specified font does not exist.
User action: Specify another font (font #1 is always loaded).
*Front panel serial bus failure* (–925)
Explanation: The serial i2c bus from the AWC to the CIP has failed. This bus is
used for I/O to the front panel and for the digital I/O signals con-
nected to the CIP. High power is disabled if a failure occurs on this
bus. This message may occur normally when certain diagnostic pro-
grams are run.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
