!"
=/
not present in the system, or it is configured for some other use. For
example, if a serial communication line is configured as a network
port, it cannot be accessed as a user serial line.
User action: Make sure the correct device is being accessed. Power down the
controller and try starting it again. Make sure the boot disk you are
using is valid for your controller. Use the CONFIG_C utility pro-
gram to make sure the serial I/O configuration is correct. If the
problem persists, contact Adept Application Engineering for assis-
tance.
If the error resulted from a disk I/O operation, it indicates that the
disk controller hardware is not configured correctly. Adept Cus-
tomer Service should be contacted in that case.
*Invalid in read-only mode* (–352)
Explanation: An editor function was attempted that cannot be performed while
accessing a program in read-only mode.
User action: Change to editing the program in read-write mode, or use a differ-
ent editor command.
*Invalid model name* (–732)
Explanation: The name of a prototype, subprototype, OCR font, or correlation
template has been incorrectly specified. The correct format for pro-
totype names is proto:subproto, where proto is a prototype name
and subproto is a subprototype name. This error occurs if the colon
is followed by a blank, or when some other character is used instead
of a colon. Font names have the form FONT_n, where n is an integer
in the range 0 to 50. (The special name FONT_0 refers to all fonts.)
Similarly, template names have the form TMPL_n. Prototype names
should not begin with FONT_ or TMPL_.
User action: Enter the attempted operation again, correctly specifying the proto-
type, subprototype, OCR font, or correlation template.
*Invalid network address* (–561)
Explanation: This error occurs when an NFS server has not correctly exported the
path being accessed or when an IP network address specified is not
of class A, B, or C.
User action: Check the IP addresses used to refer to network nodes.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General