!"
=2
*Invalid character in font* (–741)
Explanation: An invalid character appears in the string that defines a font for
optical character recognition (OCR). The characters in the string
must be in the range ASCII 33 (!) to 126 ().
User action: Delete the invalid character from the string.
*Invalid connection specified* (–540)
Explanation: An invalid logical network connection has been specified. For exam-
ple, a zero connection ID is invalid.
User action: Specify a valid logical connection ID.
*Invalid disk format* (–520)
Explanation: An attempt has been made to read a disk that is not formatted, or is
formatted improperly; or a FORMAT command has been entered
that specifies invalid format parameters for the device specified.
User action: If a FORMAT command has been entered, check the command syn-
tax and retry the command. Otherwise, try a different diskette or
reformat the current one. Remember that formatting erases all infor-
mation on the diskette. If the diskette was created on an IBM PC, be
sure it was formatted with one of the formats accepted by the V
+
system.
*Invalid error code* Belt n (–1010)
Explanation: An unrecognized error was reported by the controller for the indi-
cated conveyor belt.
User action: Attempt the operation again. If the error repeats, report the situation
to Adept Application Engineering.
*Invalid format specifier* (–461)
Explanation: An unrecognized output format specifier was encountered in a
TYPE or WRITE instruction, or in an $ENCODE function.
User action: Edit the program to use a valid format specifier.
*Invalid hardware configuration* (–533)
Explanation: An attempt has been made to access an I/O device in a manner
inconsistent with its current configuration. Either the I/O device is
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General