12
±
WARNING!: When a configuration is removed, all data logged with that configuration will also be removed! However,
all log files will remain in memory until exported to the USB drive.
• Press to add, edit, or remove information for a specific vehicle, implement or controller.
Vehicle Offsets
Vehicle offsets can be entered during configuration setup or later using configuration settings.
Vehicle offsets define where the machine’s rear axle and hitch is in relation to the GPS antenna. These settings are used for
accurate mapping and AutoSwath™.
When the process of setting up a vehicle is completed, vehicle offsets can be re-configured later.
The vehicle offsets settings consist of two tabs: the Antenna tab and the Hitch tab.
÷
NOTE!: Accuracy when measuring for a specific setting is essential to ensure proper machine performance.
Antenna Offsets tab
At the Antenna tab, enter the distance from
locations on the vehicle to the antenna.
• Measure and enter the horizontal distance
from the rear axle to the position of the GPS
antenna.
Select IN FRONT or BEHIND to indicate the
position of the antenna in relation to the
rear axle.
• Measure and enter the horizontal distance
from the center line of the vehicle to the
position of the GPS antenna.
Select LEFT or RIGHT to indicate the
position from the vehicle center line.
• Measure and enter the vertical height of
the antenna above the ground.
Your Specific
Configuration
Vehicle Offsets: Tractor
Enter Distance from Vehicle Reference to the Antenna
Antenna
Hitch
Antenna Location
from Rear Axle
Antenna Location
from Centerline
Antenna Height from
Ground
0 in
0 in
0 in
In Front
Left
To Next Page
Loading...
