65
PN 4004700–ENG Rev. K
Field Operations
Events
Events are used to track field operations. New events can be created at anytime and therefore a physical field can be broken
into many events or recorded under one. An event contains all coverage maps created while that event was active. Events
are automatically named by date and time.
The display can be run in two different modes:
• Traditional mode—requires user to specify a Grower, Farm, and Field for the Event. The display associates this
information with setup files and logged data. When these files are reviewed or utilized in the future, it provides the
operator with a greater depth of information.
• Events Only mode—minimizes the setup process so that the display is ready to run in the field with the least
amount of setup (just a few button presses).
Field Operations
To start a field operation, press one of the field operation apps from the home screen. This display has the ability to use
guidance, tillage, and surveying configurations without extra equipment. Additionally. planting and application
configurations can be created to track products without modules. The Field Operation wizard will walk through all the
steps needed to begin a field operation.
Select Field Operation app and follow the Setup wizard.
The following must be created:
• Grower, Farm, and Field if “Enable Management” is checked, otherwise the display will track operations based only
on events.
• A Season Setup within Management tab
.
• A Product (when creating an Application or Planting Field Operation) at the Setup Product tab.
• An Operating Configuration at the Setup screen’s Configuration tab. This Operating Configuration consists of
Equipment, Vehicle, Implement, Controller (optional), Tank (in Application), and Ground Speed Source.
All of these are referenced by the Field Operation wizard during the Field Operation setup process.
Planting Application Harvest
Water Management Guidance Tillage
To Next Page
Loading...
Need help?
General
