Ag Leader InCommand 800 - Port B tab; GPS Information

GPS/Steering Setup
91
PN 4004700–ENG Rev. K
÷
NOTE!: StableLoc is enabled by default when WAAS/EGNOS is selected and cannot be disabled by the user.
Operating WAAS/EGNOS with StableLoc enabled provides similar or better accuracy than operating with
WAAS/EGNOS with StableLoc disabled.
Reset to Defaults—Press the Reset to Defaults button to restore receiver settings to the factory default. This will remove
all custom settings.
NMEA Talker—This button disables the GLONASS prefix in the NMEA messages. If using the GPS receiver with legacy
displays or a device that does not support GLONASS messages, uncheck the box.
WAAS/EGNOS Settings
PRN
• Automatic
• WAAS
• EGNOS
• Custom
μ
ATTENTION!: Should be left on Automatic
unless otherwise told by support
Receiver: GPS 6500
Serial
General
Differential Source
WAAS/EGNOS
WAAS/EGNOS Settings
PRN
Automatic