Allied Telesis AT-x210-9GT - Page 1351

C613-50105-01 REV C Command Reference for x210 Series 1351
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SNMP COMMANDS
SNMP
-SERVER ENABLE TRAP
Usage This command cannot be used to enable link status notifications globally. To
enable link status notifications for particular interfaces, use the snmp trap
link-status command.
To specify where notifications are sent, use the snmp-server host command.
Note that more than one trap can be configured with one command entry, and
also note this command applied to notifications send by SNMP version 3.
Examples To enable the device to send a notification if an AMF node changes its status, use
the following commands:
awplus# configure terminal
awplus(config)# snmp-server enable trap atmfnode
To enable the device to send MAC address Thrash Limiting traps, use the following
commands:
awplus# configure terminal
awplus(config)# snmp-server enable trap thrash-limit
To disable the device from sending MAC address Thrash Limiting traps, use the
following commands:
awplus# configure terminal
awplus(config)# no snmp-server enable trap thrash-limit
Related
Commands
show snmp-server
show ip dhcp snooping
snmp trap link-status
snmp-server host