Allied Telesis AT-x210-9GT - Aaa Authentication Auth-Web

C613-50105-01 REV C Command Reference for x210 Series 956
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AAA COMMANDS
AAA
AUTHENTICATION AUTH-WEB
aaa authentication auth-web
Overview This command enables Web-based authentication globally and allows you to
enable an authentication method list (in this case, a list of RADIUS servers). It is
automatically applied to every interface running Web-based authentication.
Use the no variant of this command to disable Web-based authentication globally.
Syntax
aaa authentication auth-web default group {<group-name>|radius}
no aaa authentication auth-web default
Default Web-based authentication is disabled by default.
Mode Global Configuration
Usage There are two ways to define servers where RADIUS accounting messages are sent:
• group radius: use all RADIUS servers configured by radius-server host
command
• group <group-name>: use the specified RADIUS server group configured
with the aaa group server command
Note that you need to configure an IPv4 address for the VLAN interface on which
Web authentication is running.
Examples To enable Web-based authentication globally for all RADIUS servers, and use all
available RADIUS servers, use the commands:
awplus# configure terminal
awplus(config)# aaa authentication auth-web default group
radius
To disable Web-based authentication, use the commands:
awplus# configure terminal
awplus(config)# no aaa authentication auth-web default
Related
Commands
aaa accounting auth-web
aaa group server
auth-web enable
Parameter Description
default Configure the default authentication method list
group Use a server group
<group-name> Server group name.
radius Use all RADIUS servers.