Allied Telesis AT-x210-9GT - Page 847

C613-50105-01 REV C Command Reference for x210 Series 847
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
AUTH
HOST-MODE
To set the host mode to default (single host) on interface port1.0.2, use the
following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth host-mode
To set the host mode to multi-supplicant on authentication profile ‘student’, use
the commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# auth host-mode multi-supplicant
To set the host mode to default (single host) on authentication profile ‘student’,
use the commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# no auth host-mode
Related
Commands
auth profile (Global Configuration)
show dot1x
show dot1x interface
show running-config