Art Flystick2 - The Information File; The Setup File

8 DTrack2 frontend software
• Unplug the USB pen drive
• Reboot the controller for the changes to take effect
Now, your controller is configured according to your requirements.
8.2.4.1 The information file
This file contains the current settings of the controller. Following, a description of the file
format (e.g. ART_Controller_301422021_info.txt):
ART Controller Information:
Name : atc-301422021
Serial Number : 301422021
Ethernet (LAN) : dhcp
Ethernet IP (LAN) : 10.10.5.22 255.255.0.0
Ethernet MAC (LAN): 00:24:1D:00:C3:B3
Gateway (LAN) : 10.10.111.111
Domain Name : xyz.site
Domain Name Server: 10.10.0.1
8.2.4.2 The setup file
This file is used to:
• configure the controller to be a DHCP client,
• set a static IP address and
• to carry out a factory reset.
Z
You can find your current license codes in the file
’ART_Controller_XXXX_licenses.txt’ (will be written to USB pen
drive during factory reset)
Carrying out a factory reset will result in the loss of all your settings
including your license codes! Backup your configurations or export
your systems configuration log file beforehand (please refer to 8.4.2.1
and 8.4.2.2 on page 143).
Following, a description of the file (e.g. ART_Controller_00117_setup.txt) format:
# ART Controller Setup:
# ethernet settings:
# - uncomment just one of the lines starting with ’SETNET’
128