Chapter 9
9.10 Flystick
9.10 Flystick
The ART radio transceiver cannot be found.
Please make sure that the ART radio transceiver is plugged in. Then, simply press ’F2’
in order to perform a search for new hardware. The radio transceiver should be detected
now.
My Flystick is not listed under the available Flysticks list.
• Make sure that the battery is charged. Press any button of the Flystick and the
orange status LED should be switched on.
• Go to Settings → ART Radio Info to see if the ART radio transceiver has been
recognized.
• Go to Settings → ART Radio Info → Show details and set the channel number
manually.
Why is the pressing of the Flystick buttons not recognized (within DTrack2 )?
• Make sure that the battery is charged. Press any button of the Flystick and the
orange status LED should be switched on.
• Double-check whether the button pressed events are recognized by DTrack2 . There-
fore:
– enable the Flystick Display (Display → Flystick)
– blue rectangles should light up on each button pressed event in the Flystick
Display.
• Go to Settings → ART Radio Info to see if the ART radio transceiver has been
recognized.
• Go to Settings → ART Radio Info → Show details and set the channel number
manually.
• Go to Settings → Flystick and assign your Flystick (to be found in the available
Flysticks list) to any ’Flystick ID’.
Why is the pressing of the Flystick buttons not recognized (within the graphics
application)?
• Make sure that the battery is charged. Press any button of the Flystick and the
orange status LED should be switched on.
• Go to Settings → Flystick and assign your Flystick (to be found in the available
Flysticks list) to any ’Flystick ID’.
213
To Next Page
Loading...
