Chapter 8
8.5 Menu Settings
Info Description
Model Shows the type of camera
Serial Shows ART internal serial number of the camera
Version Shows ART internal firmware version of the camera
Focal length Shows the focal length of the camera lens
Connected at Shows the controller the camera is connected to (Cascaded
Systems only)
Below you can change the following options (please refer to the former paragraphs for
details):
Option Description
Flash intensity Change the currently selected flash intensity
Static reflex suppr. (De-)activates the static reflex suppression for this camera
Camera mode Select the camera mode (available modes depend on model)
Diplay upside down Switch display orientation by 180
◦
. ’UD’ is displayed in the
Monitor 2DOF display.
Display intensity (ART-
TRACK5 only)
Adjust the brightness of the status LEDs and the 2-digit LED
matrix display
Display mode (ART-
TRACK5 only)
(De-)activates the 2-digit LED matrix display
Sync group Select the syncgroup (’Channel 1’ - ’Channel 3’ for ART-
TRACK5 , ARTTRACK5/C & TRACKPACK/E , set individu-
ally)
Display upside down The checkbox display upside down switches the orientation of the
corresponding display in Monitor 2DOF display by 180
◦
. This setting proves to be useful
when mounting the camera upside down. Note: This setting is for display purposes only.
It does not influence the tracking system or the room calibration.
8.5.2 Synccard Settings
This dialogue shows the model and the serial number of the synccard. Furthermore, it
offers a dropdown list to select the mode of synchronization.
8.5.2.1 Synccard Modes
The available modes for synchronization are shown in table 8.8 on page 152.
151
To Next Page
Loading...
