Chapter 6
6.2 Flystick3
Battery charger A battery charger is supplied with the delivered Flystick3 and must be
used for charging the batteries. For your convenience, the battery pack may remain in-
side the Flystick3 for charging. During the charging process you may continue using your
Flystick3.
As soon as the battery pack is connected to the charger, the red LED ("Charge") is
switched on. Once the battery pack is fully charged the charger switches off the "Charge"
LED, the green "Ready" LED is switched on. Now, the battery pack may be used again.
The rechargeable batteries may only be charged with the supplied
charger.
If the green LED is switched on permanently and the red LED is flashing at the same time
an error occured during charging. The battery may be defective or it has been wrongly
inserted.
6.2.3 Radio module
The Flystick3 uses a radio module in the 2.4GHz band. This band is standardized inter-
nationally and can be used without a license. Range with line of sight is more than 7m
but can be reduced when passing material, e.g. projection screens.
6.2.4 Wireless synchronization (active Flystick3 discontinued)
The receiver for the modulated infrared signal which is used for synchronization is lo-
cated in the middle of the joint between transparent target and handpiece. This coded
signal can be generated by all ART tracking cameras, except for ARTTRACK1 and older
ARTTRACK2 (up to SN 320) cameras. However, the Flystick3 may also be used with
tracking systems where older ARTTRACK2 (< SN 320) or ARTTRACK1 cameras are
used (DTrack2 is required). For this purpose an additional external flash can be pur-
chased from ART .
79
To Next Page
Loading...
