Chapter 8
8.7 Menu Display
8.7 Menu Display
Display Shortcut
Monitor 2DOF
Data F10
Fingertracking
Flystick
Measurement Tool
Events
Set to default
Table 8.18: Menu Display
Monitor 2DOF The Monitor 2DOF display is a graphical display of the field of view
of the cameras to visualise all markers that are seen by the cameras. It is activated by
default. A more detailed description can be found in chapter 8.3.3.1 on page 135.
Data On the left hand side the Data Display shows the 6DOF measurement results (i.e.
position and orientation of the body relative to the room coordinate system). Additional
information for inertial sensors are also shown, if applicable. On the right hand side the
results for 3DOF calculation of single markers (e.g. from not calibrated targets) is shown,
if activated.
Fingertracking The Fingertracking display shows the measurement results for the hands
- i.e. of back of the hand + each finger (thumb, index, middle, ...).
Flystick The Flystick display shows the measurement results of the position and orien-
tation of the Flystick.
Measurement Tool The Measurement Tool display display shows the measurement
results of the position and orientation of the Measurement Tool .
Events The Event Display shows the status of the tracking system. All messages and
entries shown here are also stored in event logs on the remote PC. These files are nec-
essary for tech support by ART (please refer to chapter 8.4.2 on page 142).
Set to default This function resets the appearance of the DTrack2 frontend, i.e. all
views and the size of the windows are reverted to default values. Only the Monitor 2DOF
and the displays Data and Events are shown.
187
To Next Page
Loading...
