Art Flystick2 - Page 149

Chapter 8
8.5 Menu Settings
a room recalibration. Thus, a recalibration is necessary for the corresponding camera to
contribute to the tracking. Please refer to chapter 5.1.3 on page 58 on how to add new
cameras dynamically.
Z
DTrack2 is able to operate when cameras have been added or removed;
for best performance it is highly recommended to perform a recalibra-
tion
Global settings Tick the checkboxes to adjust the corresponding setting for all cameras
at once.
Global flash intensity Move the adjacent slider to level the flash intensities of all cameras
and adjust them globally.
Global camera mode Set the FoV of all cameras globally by using the dropdown-menu
(e.g. 1.1 Mpix, max. 60 Hz) to the right.
Global display intensity (ARTTRACK5 only) Move the slider to adjust the brightness of the
status LEDs and the 2-digit LED matrix display. The brightness can be dimmed from
0...100%, if necessary (e.g. in light-sensitive environments).
Global display mode (ARTTRACK5 only) Select default to activate the status LEDs and the
2-digit LED matrix display to show the currently assigned camera ID only. Alternatively
select number of markers / camera ID to display the number of detected markers in the
camera’s FoV instead (only during measurements). The 2-digit LED matrix display can
also be deactivated by selecting only status LEDs.
Modulated flash ART tracking systems can be used with active markers, i.e. markers
consisting of infrared LEDs instead of retro reflective material (see chapter 3.2 on page
21). Tick the checkbox modulated flash to activate the adjacent drop-down menu. Select
one of the cameras to emit the synchronization signal (i.e. coded IR flash) that triggers
active targets.
i
Due to the modulation the effective flash intensity is reduced when
it is used in combination with low flash intensities. The influence is
neglectible at higher flash intensity settings. Simply increase the flash
intensity, if necessary.
i
The range of the modulated flash is significantly higher than the track-
ing distance of the camera.
149