Chapter 9
9.2 Cameras
is working. If the fan stops, rising temperatures inside the camera will cause an
emergency shutdown of the internal control unit.
• If you are using an external switch, please make sure that no camera is connected
to the uplink port and, if applicable, the switch is powered up.
• Finally, reboot the cameras, the external switch and the controller.
What is the meaning of the red LEDs at the front of the camera?
They are indicating the status of the camera:
• ARTTRACK2 / ARTTRACK3 (discontinued): The left LED shows that the camera
is powered up and booted. Whereas, the right LED indicates that the measurement
is active. In case of an error (e.g. sync loss), the left LED extinguishes and the right
LED starts flashing. Please refer to figures 4.7 and 4.8 on pages 38 and 40 for the
visualization of the cameras.
• ARTTRACK5 : The lower LED shows that the camera is powered up and booted.
Whereas, the upper LED indicates that the measurement is active. In addition to
the two status LEDs the 2-digit LED-matrix on the left displays the assigned camera
ID (default) and the number of markers in the camera’s corresponding field of view
(when activated under camera settings). Please refer to figure 4.1 on page 29 for
the visualization of the camera.
• ARTTRACK5/C : The red LED on the camera body shows that the camera is pow-
ered up and booted. Please refer to figures 4.4 on page 33 for the visualization of
the cameras.
• TRACKPACK/E : The lower left LED show that the camera is powered up and
booted. Measurement active is indicated by the lower right LED. Please refer to
figure 4.6 on page 35 for a visualization of the camera.
• TRACKPACK (discontinued): The lower left LED show that the camera is powered
up and booted. Measurement active is indicated by the lower right LED. Please refer
to figure 4.9 on page 43 for a visualization of the camera.
One of my cameras recognizes a reflection which I can’t eliminate. What can I
do?
You may enable the suppression of static reflexes within DTrack2 . But carefully read the
notes in chapter 4.8.2 on page 48.
How many cameras may be connected to the tracking system?
Starting with DTrack2 version v2.10 a new license model has been established.
You may use 2, 4, 8, 16 or up to 50 cameras in any combination with 4, 10, 30 or up to 50
targets depending on the license purchased.
193
To Next Page
Loading...
