Chapter 9
9.11 Fingertracking
ter 6.4.1 on page 85.
• Increase the brightness of the LEDs on FINGERTRACKING2 devices. Please refer
to chapter 6.4.2 on page 87.
When using Fingertracking, there are always some markers that are flashing
alternately in the Monitor 2DOF display.
This is not bug, but rather it is due to the sequential activation of the finger thimble markers
in order to achieve a separation of the fingers.
What’s the meaning of the status LEDs on the Fingertracking hand target?
For Fingertracking please refer to 6.4.1 on page 85. For FINGERTRACKING2 please
refer to chapter 6.4.2 on page 87.
What is being configured when turning the configuration dial?
Please refer to 6.4.1 on page 85.
What’s the maximum number of hands to be used?
You may use two Fingertracking sets (i.e. four hands) in your tracking system at the same
time. However, the targets of the hand devices must be different.
How do I assign a hand geometry to a hand ID?
Go to Settings → Fingertracking. Please refer to chapter 6.4.6 on page 92 for further
details.
The finger calibration fails. What do I do wrong?
• The configuration dial has to be turned to the proper position. Please refer to chapter
6.4.1 on page 85.
• Go to Settings → Cameras and tick the checkbox ’modulated flash’. Only one cam-
era can emit the modulated flash, thus the selected one should have unobstructed
view of the whole tracking area. Furthermore it has to be assigned to syncgroup
#1 ! ARTTRACK5 , ARTTRACK5/C , TRACKPACK/E , & TRACKPACK systems
may be configured via software, while ARTTRACK2 & ARTTRACK3 have to be
connected to ’OUT1’ on the controller’s Synccard.
• Please observe the calibration procedure defined in chapter 6.4.6.5 on page 96.
• Make sure that you selected the correct handedness and type of fingerset (3-finger
VR vs. 3-finger AR vs. 5-finger AR) in Calibration → Fingertracking → Hand geom-
215
To Next Page
Loading...
