Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove air guide hose -arrows-.
– Remove ribbed belt ⇒ Rep. Gr. 13 .
– Remove ribbed belt tensioner ⇒ Rep. Gr. 13 .
– Install Engine Support - T10014- in ribbed belt tensioner se‐
curing hole.
– Position Engine Support Bridge - 10-222 A- with Supplement
Set - T40091/3- and 2 spindles on bolted fender edges.
• Spindles are at front.
– Engage both spindles at rear engine lifting eyes.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
2. Subframe, Stabilizer Bar and Coupling Rod 23