Baumuller b maXX BM5800 - Description of the Parameters

Configuration
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
252
of 814
3.4
3.4.14.3 Description of the Parameters
182.1 Mode
182.2 Source parameter id
Specifying the parameter number of the value to be filtered.
In general, all of the parameters with the following data types can be indicated as source
parameters:
UINT, UDINT, INT, DINT, FLOAT.
182.3 Time constant PT1 filter
This parameter indicates the smoothing time constant.
182.4 PT1 filter output
This parameter represents the filter output. The data type of the filter output is always
FLOAT, independently of the data type of the source parameter.
The output is always displayed in ProDrive as a raw value of the source parameter. A cal-
culation of the unit of the input value by ProDrive does not effect the presentation of the
output value.
Bit Meaning
0 0: Filter is switched off
1: Filter is switched on
15 ... 1 Reserved