Baumuller b maXX BM5800 - Prodrive: Encoder 1 Configuration

Performing the commissioning (using Axis 1 as an example)
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
32
of 814
2.6
The "Encoder 1 Configuration" window opens.
Figure 14: ProDrive: Encoder 1 Configuration
10 Enter data when using a sine-cosine encoder without a HIPERFACE

interface. With
a sine-cosine encoder with a HIPERFACE

interface, the data are transferred auto-
matically over the HIPERFACE

interface - do not alter the data.
m Sine-cosine without HIPERFACE

e.g. Number of Pulses = 1024
m Sine-cosine without HIPERFACE

e.g. Revolutions = 1
11 Enter the overspeed limit manually in the parameter list in the diagnostic block
[FB:006]:

Parameter number 006.005 and 006.007: enter the value 300000,
Parameter number 006.006 and 006.008: enter the value -300000