Baumuller b maXX BM5800 - Structure of the Parameter Overviews

Description of the Software Modules and Parameters
Parameter manual b maXX BM5800
Document No.: 5.16029.03
49
of 814
3
3.2 Structure of the parameter overviews
All parameter overviews are structured according to the following pattern:
Number = Number of the parameter consisting of ID of the functional block (FB) and the
numbering within the FB
Name = Common parameter name for ProDrive and Parameter Manual
Type = Data type
INT Integer 16 bit 
DINT Integer 32 bit 
UINT Unsigned Integer 16 bit 
UDINT Unsigned Integer 32 bit 
WORD Word 16 bit 
DWORD Double Word 32 bit 
FLOAT Float 32 bit 
STRING String (characters) 
RECORD Composite data type (Struct, Array, etc.)
Min = Range of values of the parameter, minimum value at internal standardization
Max = Range of values of the parameter, maximum value at internal standardization
Default Value = Default value at internal standardization
Unit = Unit of the parameter for display in ProDrive
Factor = Conversion factor F2/F1 between display ProDrive (Gui) and internal 
standardization (Para): Gui = Para * F1 / F2
X in column „Read only“ = Parameter is read-only
X in column „Storage“ = Parameter will be stored in Flash
X in column „DS support“ = Parameter will be stored in data sets of the 
Flash
O in column „Cyclic Write“ = Parameter may be written cyclic, e.g. using 
process data of the fieldbus; 
fieldbus cycle time  1 ms
X in column „Cyclic Write“ = Parameter may be written cyclic with 
fieldbus cycle time < 1 ms also
X in column „Axis independent“ = Parameter is valid for all axes of the device 
in common
Number Name Type Min Max Default Value Unit Factor
Read only Storage DS Support Cyclic Write Axis-independent
1.1 System Clock FLOAT 0 1000000000 0 sec 1:1 X X
1.2 System Ticks RT1 UDINT 0 0xFFFFFFFF 0 1:1 X X