Baumuller b maXX BM5800 - Page 326

Management
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
326
of 814
3.5
105.3 Message
Messages from the DSM resulting from command execution.
Parameter with 20 array elements. Each element has the following structure:
This parameter displays the first 20 error messages that occurred with a DSM command.
If no further messages occurred, "0.0.0.0" is displayed as the parameter number.
Parameter Z105.12– displays the number of messages.
List of the most important RC codes for DSM messages:
1401 RC_DSV_NO_VALID_PARAFILE No valid parameter file found
1402 RC_ERR_DSV_PARAFILE_CRC CRC in parameter file not correct
1403 RC_ERR_INVALID_DS Invalid data set number specified for
DSM command (copying of non-created
DS, deletion of active DS)
Value RC Code Meaning
ParaId Parameter Id, value 0 if no message
Index0 Index for Index Level 0
Index1 Index for Index Level 1
Index2 Index for Index Level 2
Index3 Index for Index Level 3
RC RC code of this message
Value RC Code Meaning
0 RC_NO_ERROR No command executed yet or else Reset
command executed.
2 RC_ERROR General error. In most cases the parameter
still exists in the new description, but no lon
-
ger in the code (old parameter which has
been removed but is still in the xml files or in
the Zx files).
160 RC_ERR_ID Id found in the parameter file does not exist
161 RC_ERR_INDEX Index in parameter file invalid
162 RC_NOT_WRITABLE Parameter is not writable
164 RC_ERR_MIN Value is less than the minimum value
165 RC_ERR_MAX Value is greater than the maximum value