Baumuller b maXX BM5800 - Page 340

Management
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
340
of 814
3.5
134.10 Opening delay
Delay between the start of the buildup of holding torque and the "Enable brake" command
in Automatic mode (
Z134.1– Bit 0 = 1). 
134.10 is only evaluated if a holding torque is to be built up before the brake is enabled
and the brake is to be enabled after a presettable time (
Z134.3– Bit 1...0 = 3). The "En-
able brake" command is issued [134.10] ms after the start of the buildup of the holding
torque.
See also ZEnabling the Brake– from page 329