Description of the Software Modules and Parameters
Parameter manual b maXX BM5800
Document No.: 5.16029.03
391
of 814
3
159.3 Status
Displays the actual state of cam generator.
159.4 List index
The instantaneously active table entry is displayed.
This index starts at 0 and ends at (count supporting points - 1).
159.5 List entries
Total count of supporting points of the active cam.
3 Time control with virtual master axis and parameter-controlled processing,
only
0: linear interpolation
1: square interpolation
4 0: specify cyclical offset manually
1: generate cyclical offset from the cam
5 0: processing one-time only
1: cyclical processing
6 0: real time mode
1: relative mode
7 Parameter-controlled processing, only
0: no auto offset
1: active auto offset
Bit no. Meaning
Bit no. Meaning
0 … 1 00: "init" state (parameterization is possible)
01: "active" state (parameterization completed and advisable)
11: "run" state (cam processing is running)
2 … 5 Reserved
6 0: no valid cam in the RAM
1: valid cam in the RAM
7 0: the output is between the minimum and the maximum value of the tar-
get parameter
1: the output was limited
To Next Page
Loading...